View unanswered posts | View active topics It is currently Thu Mar 28, 2024 3:45 am



Reply to topic  [ 12 posts ]  Go to page Previous  1, 2
 Wi-Fi Range 
Author Message
Moderator
User avatar

Joined: Mon Jan 28, 2013 7:40 pm
Posts: 2885
Location: Illinois
FL Panhandle wrote:
Forgot to mention it (just in case you didn't already know about it).. FLAT PANEL antennas are very DIRECTIONAL. (not "omni").

Typical 14dB commonly has a 60 degree spread on the signal width... but my 24-29dB flat panel.. very narrow signal beam,, is only about 3-4 degrees wide. Any snoopers / hackers who are located OUT of my signal path,, don't even find my signals. This also is good for limiting interference from other sources.


Very interesting, thanks for the share!

_________________
MY OUTSIDE RADIATION MONITORING STATION:
South Beloit, Illinois - GMC200 Outside on HEPA air purifier, ground level, facing West.
http://netc.com/chart/view.php?n=1%3AEB5A139C


Mon Mar 31, 2014 6:52 am
Profile

Joined: Sun Mar 16, 2014 9:16 am
Posts: 35
Congrats...you are on the right trail, when trying to "extend" the range of any RF signal. Amp's can get you there "sometimes"...whereas, the antenna route will insure you stay connected. In the ham world, we call this "more bang for the buck". And, a proper antenna doesn't need any "more" power from the mains or battery, ie: your power budget doesn't have to grow as much..

The term db is generic. But the "reference point" is "gain over isotropic" (dbi) or "gain over dipole" (dbd) to keep everyone honest when touting such gains for a price point. The nominal gain of a dipole, the most common antenna design which can "match" an output is 2.15db over/above "point source" theory or isotropic.

Suffice to say: IF you build a dipole and feed it with 1w of rf power you can establish a contact x% of the time; whereas, if you feed a 3/4/5 element yagi with the same 1w of rf, your success will become x+<1%. These flat panel antennas are actuall an "array" of small antennas inside a protective cover - with some complex wiring/control systems you can actually "steer" your beam horizontally and vertically...look at the radar arrays on our navy ships now...those big flat hex shaped panels on the super structure.

All of these "compact" designs work at UHF and SHF frec's - due to wavelength, like 400 MHz and on up... Hams work all the way up into the 30 and 40 Ghz bands now. At these UHF+ frec's it is true "line of sight" - most are used for point to point data links or into space itself. Very low power levels (like 100 to 400 mW) are common for our WiFi frec band..but, think of those db as a "multiplier" to your power output factor. Ie: 100mW x 10 db = EROP of 1w +/- (effective radiated output power). This "gain" is effected by the "focusing effect" of your "antenna system" (when compared to a standard, common, dipole). Think of it like your signal is distributed all around your "vertical" antenna "equally". IF you went around that circle and "took" all the signal you could from say 270 deg (3/4) of the full circle, and then "piled" it on top of that last 90 deg (1/4) of the circle -- you would end up with 4 times the orginal signal strength in that one segment (less some losses and reflected power).
I can close by saying, ham's now use a hybrid system/software of "wifi" via HF frec's. We can handle data/GUI/e-mail over many 1,000's of miles between stations during disaster recovery. We also have other software using the soundcard in our PC's to enable us to communicate with 800-1,000w of RF BOUNCED OFF THE MOON AND RETURNED TO THE EARTH...we call it EME. And, yes, it takes some very high gain antennas with tracking drives! Check it out on ARRL.com ... Check-6


Wed Apr 02, 2014 3:51 pm
Profile
Display posts from previous:  Sort by  
Reply to topic   [ 12 posts ]  Go to page Previous  1, 2

Who is online

Users browsing this forum: No registered users and 35 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group
Designed by STSoftware.