NETC.com
https://www.netc.com:443/bb/

Do you see Berlin Wisconsin? Ok..it reads Oshkosh.
https://www.netc.com:443/bb/viewtopic.php?f=23&t=494		 Page 1 of 1
Author:  mike454 [ Wed Nov 27, 2013 12:30 pm ]
Post subject:  Do you see Berlin Wisconsin? Ok..it reads Oshkosh.
OK I think I figured it out....can some tell me if they see Berlin Wisconsin?
Author:  mike454 [ Wed Nov 27, 2013 1:06 pm ]
Post subject:  Now I can't get it to read the serial port.
Everything was working fine until I accidently closed out the window, I tried to retrace my steps from before but I can't get it to work....any help please? Mike.
Author:  KingCobra [ Wed Nov 27, 2013 1:57 pm ]
Post subject:  Re: Do you see Berlin Wisconsin? Ok..it reads Oshkosh.
I see it on the map right now. 8-)
Author:  mike454 [ Sun Dec 01, 2013 8:47 am ]
Post subject:  Re: Now I can't get it to read the serial port.
I got it working....I don't know how but I hit system restore.... but the restore point was 12-1-13. So I don't know how that would affect anything....but I'll take. :D
Author:  KingCobra [ Sun Dec 01, 2013 10:43 am ]
Post subject:  Re: Do you see Berlin Wisconsin? Ok..it reads Oshkosh.
Your CPM were too high. You said you were using uSv/h rather than CPM. I see you corrected it now, thank you & welcome to the network. We are very happy to have your station on the map 8-)

You might want to clear your data so the previous high reads are erased.

You can reset your data & by:

1. Log-in to NETC
2. Go to the main page http://www.NETC.com
3. You will see your username in the top left corner, click on the blue plus sign.
4. Under the far right column labeled "location set" your current location is blue, click on that.
5. A new screen will pop-up (make sure browser pop-ups are allowed) click on "clear chart data"
6. Now click on "EXIT"

While working on this screen in the past, sometimes it does not seem like it responds so you might have to go into this menu/screen a few times. Also remember that it will take the system about 10 minutes to get more data and post it into the chart on the NETC map so a little patience is required. 8-)
Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/