NETC.com https://www.netc.com:443/bb/ |
|
Getting data from my Inspector Alert V1 https://www.netc.com:443/bb/viewtopic.php?f=23&t=588 |
Page 1 of 1 |
Author: | Morellio [ Wed Dec 18, 2013 12:34 am ] |
Post subject: | Getting data from my Inspector Alert V1 |
Are there any solutions for this other than the $99 software/cable they offer? The licensing on it looks terrible (locked to one machine, pay $90 every time your rig dies), and all it's doing is monitoring the 5V pulses from a 3.5mm audio cable. I'm almost tempted to sell this thing and get a V2. |
Author: | TampaBay1 [ Wed Dec 18, 2013 8:36 pm ] |
Post subject: | Re: Getting data from my Inspector Alert V1 |
I have a inspector EXP without the usb interface. The output pin toggles 0v to 5v, it's the tip of the audio jack. Although I haven't tried this but if the free NETC software supports usb then you just have to connect the inspector to pins 2 & 3 of the usb (two center pins) pins 1 and 4 are usb device power. |
Author: | KingCobra [ Wed Dec 18, 2013 9:15 pm ] |
Post subject: | Re: Getting data from my Inspector Alert V1 |
I own an InspectorEXP and a Mazur 9000, both of which I took offline after buying a GMC-200 and GMC-300. They both come with the needed data cables. Save your pancake geiger counters for field testing. |
Author: | hey [ Wed Dec 18, 2013 10:26 pm ] |
Post subject: | Re: Getting data from my Inspector Alert V1 |
there is a chip in the USB cable, you can buy the cable from GQ Electronics Harlan |
Author: | TampaBay1 [ Thu Dec 19, 2013 6:50 pm ] |
Post subject: | Re: Getting data from my Inspector Alert V1 |
hey wrote: there is a chip in the USB cable, you can buy the cable from GQ Electronics Harlan Correct, I didn't think my reply through. I do plug my EXP directly into a counter but USB connection needs isolation. I also labeled the output port "audio", duh. I agree with cobra keep the inspector for field stuff. |
Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |