Trying set set things up but running into a block wall.

The GMC-300E is working fine. My wireless system is working fine (otherwise I wouldn't be typing this post). Router is broadcasting SSID. Raspberry is on and the blue light is flashing. Plugged in USB cable and all the lights on the Raspberry come on. I open up explorer and type in my PI MAC ID and get the setup page. I click the "wireless" tab and I am looking for a "configure" button or tab described in the instructions -- but there is none. And it is not detecting my SSID as a visible network (though my SSID is visible to all other devices in the house) and it detects another weak signal from the house next door. Why am I invisible to the Raspberry?

Just in case, I make sure my router is configured to allow connections even though not broadcasting the SSID (though it IS broadcasting the SSID), and then try to configure it manually . . . but no luck. After entering the SSID, confirming WPA security, and entering in the password, I get a message over and over again "This page cannot be displayed."

Any ideas what I am doing wrong?

I will have our tech guy email you. What is your PI-MAC-ID??
Harlan

Thanks Harlan!

EB40858B